Images shown on this page are SVGZ files. You will need an SVG Viewer plug in to view these images.
Because the images are vector-art, you can right-click on the images to zoom in or out as required.
GENERAL DESCRIPTION
The fully inground weighbridge design is a design where the foundation and deck is cut in to the ground (similar to the semi-inground design). The fully inground design, however, typically has a much deeper pit and the entire deck 's top surface is at ground level. There is no part of the deck that extends above ground level.
The design is commonly used for installing a weighbridge in a large driveway or pavement area where traffic can drive from one side of the weighbridge to the other without hindrance, providing the particular state's Trade Measurement Authority does not require kerbing (see the diagram at right) .
LEGAL REQUIREMENTS
The following are requirements by legislation specific to each Australian state and territory:
The digital indicator must be located within 6m from the weighbridge deck.
Access to the loadcells is incorporated into the design with the side walls or the deck.
Vehicles are not permitted to turn while entering or exiting the deck.
For a deck less than 18m in length, the approaches must be a minimum length of 3m.
For a deck 18m or greater in length, the approaches must be a minimum length of 1m.
Approaches must be constructed of concrete.
Suitable drainage must be incorporated in to the design.
Remember, our experience in the weighbridge industry means we are familiar with the relevant legislation and its application in each state and territory. We are happy to provide you with advice to allow you to comply with legislation.
